PM question

[TangledWeb3917]

I was thinking about raising a pure strike PM for my female beast hunter ... but I found the PM simulator and i tried a few diff combos, and discovered a PM that spelizazes in claws (a model i havent seen yet) ... to make her i need to get my stats to be 20-20-20-20 and at the point im at with my PM i can still go that way if i wanted too.

I was just wondering ... would it be worth it making a PM like that or would it be best to just go for pure strike. would the atp for the claw PM be considerably less then the strike PM?

[Zakuro]

It depends what you are making the PM for. I plan on using mine mainly for synthing, so am going with 4 pure PMs, one of each type. You get a small increase in synth % for a few levels (5 I think) of the proper type, so a pure one will be more likely to produce items than a hybrid.

I can't really speak on their combat effectiveness since I've never had a claw PM. I don't think the way it is leveled affects the stats of the PM though. Most likely they are all balanced in their own ways so they are all effective when used properly.

[Randomness]

Actually, it doesnt need to be 20-20-20-20. If you raise striking just enough for the dragon, and dont raise it any more, I believe it goes to claws... Theres a table on psupedia of the evolutions.

[TangledWeb3917]

well actually I stumbled across this PM simulator

http://www.inconsequentialexistence.com/psu/

I think i'll make mine 20 > 0 > 30 > 30 for my force ... and raise a pure tech PM with my hunter ^_^




<font size=-1>[ This Message was edited by: TangledWeb3917 on 2006-11-09 16:12 ]</font>

[EJ]

for the 420 you just need striking <30 and range <20 to make her.

[Realmz]

i personally would push pow to 29, then just push armor since it's the cheapest thing in the world to up at a good rate (16 levels every 24 hours) then tada 420

[TangledWeb3917]

what should i feed the PM to raise armor? what would be the best / quickest way to get that up?