Results 1 to 3 of 3
  1. #1
    Rappy Hunter
    Join Date
    Feb 2001
    Location
    Lowell, Mass, USA
    Posts
    97

    Default

    I made a HUnewearl again and powered through Forest 1 and 2 without doign any quests and decided I would try to take down the Dragon at lv 4, so I went in and basically slaughtered the dragon used just 1 resta and 1 monomate the entire fight, however when i killed the dragon and it went into its little death throes there, I was standing beneath its head, and well thwap! when it head slammed into the floor it squished me for my entire 64 hp killing me instantly.

    My brother was watching me the entire time and the room burst into fits of laughter at this. Some dragon slayer she turned out to be =)

  2. #2
    d to the ios p to the adre
    Join Date
    Feb 2001
    Location
    The land of the bitter.
    Posts
    578

    Default

    that happened to my brother after he had died fighting the thing like 15 times in a row. ive never heard more swears in such a short amount of tim before.

  3. #3

    Default

    This is why you stand on the RIGHT of the Dragon when your attacking it. (The Dragon's left) In the death scene, the dragon falls onto it's left side and anyone standing over there is gonna get smashed as if they had been standing under The Dragon when it landed.

Similar Threads

  1. Mag: Which Mag is better for a HUnewearl?
    By Claudine in forum PSO: Mag, Quest, Item and Section ID
    Replies: 13
    Last Post: May 30, 2004, 01:57 PM
  2. Best Mag for a HUNEWEARL and WHY
    By AquaFlare7 in forum PSO: Mag, Quest, Item and Section ID
    Replies: 23
    Last Post: Nov 21, 2003, 11:06 PM
  3. Mag: Is this a good Mag for my HUnewearl??
    By PalRappy in forum PSO: Mag, Quest, Item and Section ID
    Replies: 8
    Last Post: Aug 20, 2003, 01:47 PM
  4. Chaos Bringer = Death For Forces
    By DualHydra in forum PSO General
    Replies: 30
    Last Post: Aug 10, 2003, 09:40 PM
  5. Suggested ID for a HUnewearl
    By Goldstix69 in forum PSO: Mag, Quest, Item and Section ID
    Replies: 10
    Last Post: Jan 26, 2003, 03:57 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •